Pentair SunTouch - Advanced Menu (8;14): Reset Factory; Diagnostics Menu (9;14): Firmware Rev; Diagnostics Menu: Solar Temp; Diagnostics Menu: Self Test

25
SunTouch
®
Control System Installation and User’s Guide
Advanced Menu (8/14): Reset Factory
SunTouch
®
Control System conguration data is stored and retained in “Flash” memory in an EEPROM
located on the SunTouch Control System motherboard. The SunTouch Control System user system
conguration data can be erased to restore the factory defaults settings. If the optional QuickTouch
®
QT4
Wireless Remote is installed it will need to be recongured.
Reset to factory default settings
Menu button: Select the Advanced 8/14 menu.
Right button: Press this button until RESET FACTORY ERASE ALL? setting is
displayed.
Up/Down button: Select Yes to continue. Select No to exit the setting.
Right button: Press this button to continue. “Erase Memory” is displayed.
Up/Down button: Select Yes to continue. Select No to exit the setting.
Right button: Select Yes to erase system data and restore the factory default
settings. The display will return to the main screen. CAUTION: This procedure will
erase all system settings. Select No to exit the setting.
Diagnostics Menu (9/14): Firmware Rev
Displays the current rmware revision for the SunTouch Control System.
Menu button: Select the Diagnostics 9/14 menu.
Right button: View the SunTouch Control System rmware revision.
Left button: Press the Left button to return to the main status screen.
Diagnostics Menu: Solar Temp
Displays the current solar temperature.
Menu button: Select the Diagnostics 9/14 menu.
Right button: Press the button until SOLAR TEMP displays. Use this feature for
testing purposes and to verify the sensor temperature is connected and operating
correctly.
Left button: Press the Left button to return to the main status screen.
Diagnostics Menu: Self Test
To run a system self test:
Menu button: Select the Diagnostics 9/14 menu.
Right button: Press the button until Enter SELF TEST displays.
Up/Down button: Select Yes to continue. Select No to exit the Diagnostics menu.
Right button: Start the SunTouch Control System self test. The test includes testing
the control panel, air and water sensors and valves. Follow the on-screen instructions.
After the test has been completed, the status screen will displays the results. A
successful test will display - Status: Passed - Code: None. See page 66 for error
codes.
Left button: Press the Left button twice to return to the main status screen.
Diagnostics Menu: IntelliChem
®
Controller
To view the current IntelliChem
®
Controller pH and OPR status an RS-485 cable must be connected to the
COM port on the SunTouch Control System (see page 56) and IntelliChem Controller circuit board.
Menu button: Select the Diagnostics 9/14 menu.
Right button: Press the button until IntelliChem control system is displayed.
Left button: Press the Left button twice to return to the main status screen.
Firmware Rev
Rev: 2.0
Main Menu 9/14
Diagnostics
Status: Passed
Code: None
Solar Temp
Temp: 77 F
Enter
Self Test? Yes
Main Menu 9/14
Diagnostics
Main Menu 9/14
Diagnostics
Reset Factory
Erase All? Yes
Main Menu 8/14
Advanced
Erase Memory?
[YES ]
SunTouch
7:30 AM
IntelliChem
pH: 7.50 ORP:735