Pentax Optio W80 - Changing the Start-Up Screen

220
7
Settings
You can choose the start-up screen displayed when the camera is turned on.
You can choose any of the following images as the start-up screen:
• The Guide Display Start-up Screen showing a guide to the shooting
modes and buttons
• Optio logo (3-types)
• One of your own images (compatible images only)
1 In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2 Use the four-way controller
(2345) to select ^ (Start-up
Screen).
3 Press the 4 button.
The image selection screen appears.
4 Use the four-way controller (45)
to choose the image for the start-
up screen.
Only images suitable for the start-up screen
are displayed. You can also choose one of the
3 PENTAX logos or the Guide Display Start-
up Screen already stored in the camera.
5 Press the 4 button.
The setting is saved.
Changing the Start-up Screen
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card is formatted.
• Select [Off] to hide the start-up screen.
• The start-up screen is not displayed when you turn the camera on in
the playback mode.
• Images or movies taken at , , and F cannot be used for the
start-up screen.
Start-up Screen
Start-up Screen
Start-up Screen
MENU
For setting a captured
image as the Start-up
Screen
2 / 2
2/2
OK
OK
OK
OK
Cancel
Cancel
Cancel
OK
OK
OK
OK
Cancel
Cancel
Cancel
100
1 0 0
-
0017
0 0 1 7
100
-
0017
MENU
16:9 3:2
e_kb485.book Page 220 Friday, July 3, 2009 9:18 AM