USER MANUAL
Peplink Balance Series
http://www.peplink.com - 95 - Copyright © 2010 Peplink
Important Note
Under HA mode, Dynamic DNS is not supported. During a failover or fail-back, the active Peplink
Balance does not perform Dynamic DNS updates. As a result, the resolved addresses may not be the
IP address of the active Peplink Balance unit.
For Balance in NAT mode, the VIP should be set as the default gateway for all hosts sitting on the LAN
segment. For example, a firewall sitting behind the Balance should set its default gateway as the VIP
instead of the IP of Master Balance.
In Drop-in mode, no other configuration needs to be set.
Please be noted that Drop-in WAN cannot be configured in LAN Bypass port when it is configuring
High Availability.
To Next Page
Loading...
