Pepperl+Fuchs K23-SSI/USB/25B-C - PARALLEL VALUE; PARALLEL UPDATE TIME (s); SPECIAL PIN FUNCTION

K23-SSI/USB/25B-C | OPERATING SOFTWARE OS6.0
43
Value
Designation
Function
Logic 0 corresponds to HIGH at parallel output
PARALLEL VALUE
The value stored under this parameter appears directly at the parallel output if the
"Parallel Mode" parameter was previously set to values greater than 2. The
parameter has the serial access code "B1" and can be written via the serial
interface.
This function can be useful for testing the outputs and the wiring:
Value
Function
-16777216
Smallest Value
0
Default Value
+16777215
Highest Value
PARALLEL UPDATE TIME (s)
Determines the refresh time of the parallel output.
Value
Function
0.001
Minimum update time in seconds
0.010
Default Value
9.999
Maximum update time in seconds
SPECIAL PIN FUNCTION
Determines the function of the 24. and 25. parallel output. (PIN24 + PIN25)
Value
Designation
Function
0
DATA & DATA
Pin 25 : Data output (Bit 25)
Pin 24: Data output (Bit 24)
1
ERROR & DATA
Pin 25 : Error output (Active High)
Pin 24: Data output (Bit 24)
2
/ERROR &
DATA
Pin 25 : Error output (Active Low)
Pin 24: Data output (Bit 24)
3
ERROR &
/ERROR
Pin 25 : Error output (Active High)
Pin 24: Error output (Active Low)
4
DATASTABLE &
DATA
Pin 25 : Datastable output (Active High)
Pin 24: Data output (Bit 24)
5
/DATASTABLE
& DATA
Pin 25 : Datastable output (Active Low)
Pin 24: Data output (Bit 24)
6
DATASTABLE &
ERROR
Pin 25 : Datastable output (Active High)
Pin 24: Error output (Active High)