K23-SSI/USB/25B-C | GENERAL INFORMATION
8
2. General Information
The device is designed as a signal converter with control inputs, which converts
the corresponding sensor or encoder information into a parallel signal. It is also
possible to convert serial data to a parallel format. Its extensive functions and
operating modes make it universally applicable.
2.1 Operating Modes
In general, all functions must be configured in the parameter menu. The device
can be used in the following operating modes:
Operation as a frequency converter for incremental input signals
Operation as a position converter/counter for incremental input signals
Operation as an absolute value converter for SSI signals
Operation as absolute value converter for signals of a start-stop interface
2.2 Function Diagram
2.3 Power LED / Error Messages
The device has a green LED on the front film. This lights up continuously as soon
as the supply voltage of the device has been established. If an error occurs, the
LED flashes in a 1-Hz cycle. The analog output is also modulated with 0 V or
0/4 mA. When there is no longer an error, the LED automatically lights up
continuously again and the analog output reacts once more to the result currently
pending.
The exact error can be read out on the user interface (OS 6.0) via the serial
interface. ( Variable: Error_Status, Code: ";3"). See Chapter 4.
To Next Page
Loading...
Need help?
General
