http://www.pepwave.com 26 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
Select Auto, InControl, or AP Controller as your remote AP management method. When Auto
is selected, your access point will automatically choose the appropriate mode.
7.1.7 Configuration
In section, you can manage and backup access point configurations, as well as reset your access
point to its factory configuration. Backing up your access point’s settings immediately after
successful initial setup is strongly recommended.
Restore The Restore Factory Settings button resets the configuration to factory default
settings. After clicking the button, click the Apply Changes button on the top right
Configuration to corner to make the settings effective. To save existing network settings when restoring Factory
Settings factory settings, check the Network Settings box before clicking Restore Factory Settings.
Download Active
Configurations
Click Download to backup the current active settings.
To restore or change settings based on a configuration file, click Choose File to locate
Upload the configuration file on the local computer, and then click Upload. The new settings
Configurations can then be applied by clicking the Apply Changes button on the page header, or you can
cancel the procedure by pressing discard on the main page of the web admin interface.
To Next Page
Loading...
