Pepwave AP One Series - System Controller Management

http://www.pepwave.com 25 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
SNMPv3 User
Name
Enter a user name to be used in SNMPv3.
Authentication
Protocol
Select one of the following valid authentication protocols:
• NONE
• HMAC-MD5
• HMAC-SHA
When HMAC-MD5 or HMAC-SHA is selected, an entry field will appear for the password.
Authentication
Password
Enter a password to use with the selected authentication protocol.
Confirm
Authentication
Password
Re-enter the authentication password.
Privacy Protocol
Select None or CBC-DES as the SNMPv3 privacy protocol. When CBC-DES is selected, an entry
field will appear for the password.
Access Mode
Select Read Only or Read and Write as the SNMPv3 access mode.
Status
Use these controls to enable or disable SNMPv3 access.
7.1.6 Controller
In the Controller section, you can set up Peplink InControl or AP Controller remote
management.
Controller Management Settings
Controller
Management
Check this box to enable remote management.