Pepwave AP One Series User Manual

http://www.pepwave.com 54 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
10 Restoring Factory Defaults
The following procedure restores the settings of your access point to factory defaults:
• Power on the unit and wait for one minute.
• Press and hold the reset button for at least five seconds, then release.
• The unit will automatically reboot.
• Wait for one minute or until the status LED turns green, upon which the settings of the
device will have been restored to the factory defaults.
By default, the unit will acquire an IP address from a DHCP server.

Pepwave AP One Series Specifications

General

Wi-Fi Standards	802.11a/b/g/n/ac
Frequency Bands	2.4 GHz, 5 GHz
Ethernet Ports	2 x Gigabit Ethernet
Security	WPA3, WPA2, WEP
Antennas	Internal antennas
Mounting	Wall or ceiling mount
Power over Ethernet (PoE)	802.3af/at