Pepwave AP One Series User Manual

http://www.pepwave.com 27 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
7.1.8 Reboot
This section provides a reboot button for restarting the system. For maximum reliability, your
access point can equip with two copies of firmware, and each copy can be a different version.
You can select the firmware version you would like to reboot the device with. The firmware
marked with (Running) is the current system boot up firmware.
Please note that a firmware upgrade will always replace the inactive firmware partition.
7.2 AP
Use the controls on the AP tab to set the wireless SSID and AP settings, as well as wireless
distribution system (WDS) settings.
7.2.1 Wireless SSID
Wireless network settings, including the name of the network (SSID) and security policy, can be
defined and managed in this section.

Pepwave AP One Series Specifications

General

Wi-Fi Standards	802.11a/b/g/n/ac
Frequency Bands	2.4 GHz, 5 GHz
Ethernet Ports	2 x Gigabit Ethernet
Security	WPA3, WPA2, WEP
Antennas	Internal antennas
Mounting	Wall or ceiling mount
Power over Ethernet (PoE)	802.3af/at