http://www.pepwave.com 42 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
This field specifies the VLAN ID to tag to management traffic, such as AP-to-AP controller
communication traffic. The value is 0 by default, meaning that no VLAN tagging will be applied.
NOTE: change this value with caution as alterations may result in loss of connection to the AP
controller.
Checking this box enables spanning tree protocol, used to prevent loops in bridged Ethernet LANs
When this box is checked, your access point can be scheduled to reboot automatically on a
recurring basis, as indicated by the values under the Schedule, Day, and Time headings.
Select a speed and duplex setting for sending and receiving. When selecting a speed manually,
you can also control whether the access point’s speed will be advertised on the network by
checking or unchecking the Advertise Speed box. When Auto is selected, your access point will
automatically negotiate speeds.
Your access point can act as a bridge or as a router, depending on your selection here. When
Router is selected, you can additionally select whether the access point will function in NAT or IP
Forwarding mode.
To Next Page
Loading...
Need help?
General
