http://www.pepwave.com 44 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
Check to enable the DHCP server feature of your access point. Enabling DHCP is the best option
for most users. The following options will be enabled once you have checked and enabled the
DHCP server.
Enter the first and last IP addresses of the range of addresses that your access point will make
available to DHCP clients. The default range is from 192.168.1.100 to
192.168.1.200, with 24-bit subnet mask.
Enter the broadcast address that DHCP clients will use when communicating with the entire LAN
segment. The default value is 192.168.1.255.
Enter the default gateway address that DHCP clients will use to access the internet. By default,
this address will be the same as your access point’s IP address on the LAN.
In DNS 1, enter the IP address of the primary DNS server offered to DNS clients or accept the
default of 192.168.1.1, which is your access point’s address on the LAN. You can also specify up
to two additional DNS servers to use when the primary server is busy or down.
Specify the length of time that an IP address of a DHCP client remains valid. When an address
lease time has expired, the assigned IP address is no longer valid, and renewal of the IP address
assignment is required. By default, this value is set to one day.
To reserve certain addresses for specific clients, such as network printers, enter
the device’s MAC Address and a static IP to be assigned to the device. Click to add
the DHCP reservation. To delete a DHCP reservation, click .
To Next Page
Loading...
Need help?
General
