6
56 Workshop Manual, TPD 1458E, issue 3 - Perkins Confidential: Green
400 Series
Camshaft and tappets
To remove and to fit Operation 6-6
Caution: Remove the lift pump see Operation 11-2 and the fuel injection pump see Operation 11-3 before
removing the camshaft.
Note: If the camshaft assembly is replaced the fuel adjustment screw must not be altered from the original
setting. The maximum no load speed must be checked after assembly.
Lubricate the tappets with clean lubricating oil before assembly.
H1073
1
To Next Page
Loading...
Need help?
General