Perlick BBS60 - Step; Figure 8-5. Removing Front Panel; Figure 8-6. Bearing and V-Block; Figure 8-7. Door Hinges

Back Bar Service Manual
Return to Table of Contents Service Instructions - Door, Drawers, and Shelving Page 8-3
STEP 7.
Remove front panel from door assembly by
removing inner mounting screws (4 per side)
from perimeter of door assembly. See Figure 8-5.
Rotate front panel 180° top to bottom. Reattach
using same screw and mounting holes.
Figure 8-5. Removing Front Panel
STEP 8.
Insert bearing into door top hinge bracket. See
Figure 8-6.
STEP 9.
Insert V-block into door bottom hinge bracket
and attach with e-clip. See Figure 8-6. Note the
orientation of V-block.
Figure 8-6. Bearing and V-Block
STEP 10.
Attach top and bottom door hinges using screws
removed in STEP 6. See Figure 8-7.
Figure 8-7. Door Hinges