Perma PRO 250 - Page 69

Technical Data
Translation of the Original Operating Instructions
perma PRO / PRO C MP-2
The perma PRO / PRO C MP-2 lubrication system supplies 2 lubrication points with the same amount of lubricant.
It is mainly used for lubrication on motors, fans, and pumps.
PleasenotethatthisPRO/PROCMP-2operatingmanualmustalwaysbeusedtogetherwiththeoperatingmanualfor
PRO/PROC.ThebasicfunctionofPRO/PROCdoesnotchange.Theonlydifferenceisthatthe lubricant amount is
distributed evenly between two lubrication points.
ThePRO/PROCoperatingmanualremainsvalid.Anydifferencesofthe2-pointdistributionarecoveredinthisoperating
manualwhichshouldbeusedinadditiontothePRO/PROCoperatingmanual.
ATTENTION!
The lubrication system perma PRO / PRO C MP-2 only functions with the distributor
PRO / PRO C MP-2. If the distributor is disconnected the lubrication system does not work.
perma PRO / PRO C MP-2 Distributor
Length 67mm
Diameter 49mm
perma PRO / PRO C MP-2 Distributor 265g
Number of outlets 2
Maximum working pressure 25bar(360psi)
Lubricants GreaseuptoratedconsistencyNLGI2
Ambient temperature -20°Cto+60°C/-4°Fto+140°F
Connection thread for grease line G1/8inside
Diameter of grease line 8x1,5/InsideØ5mm
Length of the grease line
admissibletotallengthperlineupto5m.Fordetailspleaseregard
operatingmanualPRO/PROCchapter3,chart1
Emission sound pressure level <70dB(A)
Storage conditions Dry,dust-freeattemperaturesof+20°C±5°C/68°F±9°F
Discharge amount per outlet / stroke 0,25cm
3
ATTENTION!
Never close an outlet and never connect a grease line with more than 25 bar counter pressure.
Doing so will cause a system malfunction.