LiquidWatch Installation Manual
29
PROBE # 01 ACTIVE
“TIME” “DATE”
PROBE # 01 BREAK
“TIME” “DATE”
PROBE # 01 SHORT
“TIME” “DATE”
END OF HISTORY
NO MORE MESSAGES
MAIN MENU 4 OF 5
DISPLAY SETUP
PROBE– 01 RELAY– 00
TYPE HYDROCARBON 255
LiquidWatch archives 3 types of faults:
When the history has scrolled to one end, the message is:
Return to the Main Menu at any time by pressing “M”.
5.6 Display Setup
The Display Setup function shows the probe type, associated output relay (if any) and a diagnostic
number, for all probes that are setup. To select Display Setup, scroll in the Main Menu to function 4 and
press “Enter”.
The first line displays the probe number and output relay, which is associated with the probe. A listing of
“RELAY-00” means no output relay module relay is assigned and only the common alarm relay activates
when the probe is in a fault condition. The second line displays the type of probe and a diagnostic
number (0-255).
If the data is incorrect, return to the Setup function and reenter the data. Press one of the scroll keys to
select another probe or press “M” to return to the Main Menu.
5.7 Configuration
The Configuration Menu has 7 functions:
1. Test Mode
2. Time and Date
3. Number of Probes
4. Number of Relays
5. System I.D.
6. Baud Rate
7. Version
Select function 5, Configuration, from the Main Menu and press “Enter”.
To Next Page
Loading...
Need help?
General
