Pertici WM1L/E - Optional;Spare Parts; Conformity with Safety Standards

Instruction manual for use and maintenance
for WM1L/S WM1L/S-M WM1L/E Single
head machines
File: 1927.doc - 25/01/02 11:55
13
UNIVER WM1L/E
Welding at 90° and intermediate angles between 40° and 180°
Non-removable blades for welding seal limitation (not heatable)
Limitation of standard welding seal thickness (2 mm)
Reduction of 2.5 mm. of the welded profile length for each welded profile side
"Safe touch" safety device on profile clamping kit
Adjustment of fusion pressure
Electronic panel acting as machine-operator interface with the following functions:
- Setting and automatic control of fusion plate temperature
- Setting and control of fusion and cooling times
Time-
controlled (not by a limit switch) working cycle and handled by an electronic
controller
3.5 Optional/Spare parts
UNIVER WM1L/S – WM1L/S-M
Heated blades for welding seal limitation (compulsory for a welding seal limitat
ion of
0.2 mm)
Kit for variation of the welding seal thickness from 2 mm. (standard) to 1 mm
Kit for variation of the welding seal thickness from 2 mm. (standard) to 0.2 mm
Profile holding arms
UNIVER WM1L/E
Kit for variation of the welding seal thickness from 2 mm. (standard) to 1 mm
Profile holding arms
3.6 Conformity with safety standards
The welding machines type UNIVER WM1L-S have been designed and built in compliance with
the following directives:
EEC STANDARD 89/392 and following modifications (Machine directive).
EEC STANDARD 89/336 and following modifications (electromagnetic compatibility).
The following standards and technical specifications have been used:
D.P.R. N°547 (27.4.1955)
EN 60240-1 standards (September 1993) IEC 44-5/IInd edition.
EN 292-1 (1991)and UNI EN 292, part 1, standards.
EN 292-2 (1991) UNI EN 292, part 2, standards.
EN 50081 - 1 (1992) standards.
EN 50082 - 1 (1992) standards.