Instruction manual for use and maintenance
for WM1L/S WM1L/S-M WM1L/E Single
head machines
File: 1927.doc - 25/01/02 11:55
22
ATTENTION
THE SAFE TOUCH SAFETY DEVICE ACTS ONLY ON BARE HANDS
THE USE OF GLOVES IS THEREFORE PROHIBITED DURING THE NORMAL WORKING
CYCLE
Verify if the device works properly at every machine start, carrying out the safety test by
touching the front panel and one blocking plate.
On the machine display will periodically appear the message “CARRY OUT SAFETY
TEST“ during the working cycles.
DWG. A1.18
5.3 Operating cycle
To carry out a welding cycle act as follows:
- Check if the pneumatic and the electric connection has been carried out.
- Turn the main switch to position “1”
- The display shows:
WAIT FOR THE MACHINE
AT TEMPERATURE
T:210.0>245 T:35>40
1
To Next Page
Loading...
