holes on the bottom of the Lightning Protector.
WARNING: Verify the loop and transmitter wires are connected to the proper
Lightning Protector terminals. Damage to the Lightning Protector and transmitter
can occur if connections are reversed.
6. Plug the transmitter power AC adapter into an AC outlet on the side of the
Lightning Protector (see diagram).The AC adapter cord may be secured to the
bottom of the Lightning Protector using the included wire tie.Turn on the contain-
ment system.
If you have added the Lightning Protector to an existing containment system,
check the signal field for width and continuity. Adjust as necessary. If the
Lightning Protector is being installed with a new system, follow the signal field
adjustment procedures given in the containment system's owner's guide.
To Next Page
Loading...
