Adjustment
7
15
.08 Aligning the button clamp
Requirement
The button clamp should be aligned in "X" and "Y" direction, so that the needle penetrates
the centre of the gauge button.
● Insert gauge button 1 (part number 61-111 635-66) and switch on the machine.
● In the input mode select parameter "609", see Chapter 11.03 Parameter input of the
instruction manual (machine moves to "0-position").
● If necessary, enter the access code, see Chapter 11.05.01 Entering the access code in
the instruction manual.
● Adjust button clamp 2 (screws 3) in "X and Y direction" in accordance with the
requirement.
● Conclude the input, remove the gauge button and switch off the machine.
Fig. 15 - 03_a
3
2
1
To Next Page
Loading...
Need help?
General
