Adjustment
41
15.36 OTE-errors
1 Read error
2 Write error
3 Full EEPROM
4 No EEPROM
5 Invalid size
6 Invalid address
7 Address overflow
8 Checksum falled
9 Serialnr. changed
ERROR: 407 Zero points invalid
ERROR: 408 Machine not in basic position
ERROR: 409 Zero point not found
ERROR: 410 Program too long
ERROR: 411 Incorrect program number
ERROR: 412 Incorrect number of holes in button
ERROR: 413 Coordinates of 2 holes are the same
ERROR: 414 Incorrect number of plies
ERROR: 415 Incorrect stitch formation value
ERROR: 416 Error in SD-memory card reader
1: No SD-memory card inserted
2: Wrong SD-memory card (does not match the machine)
3: SD-memory card not inserted correctly
4: SD-memory card with write protection
5: Data error on SD-memory card
6: Formatting failed
7: File does not match machine
8: Incorrect file size
9: Transfer error
10: Data cannot be deleted
11: Sewing head recognition unit not connected
ERROR: 417 No penetration point found for winding
ERROR: 418 1st penetration point for winding is located outside the sewing area
ERROR: 419 Incorrect number of sewing-on stitches
ERROR: 420 Incorrect number of attaching stitches
15.35 Sewing motor errors
1 Time out
2 Position not reached
33 Invalid parameter value
34 Brake path too short
35 Communication error
36 Initialisation (Init.) not completed
37 Command overflow
64 Mains OFF during initialisation
65 Overcurrent directly after mains ON
66 Short circuit
68 Overcurrent in operation
69 No increments
70 Motor blocking
71 No incremental connector
73 Motor running interrupted
74 Incremental transmitter
missing for speed increase /
reduction
75 Controller locked
170 Invalid transmission
171 Zero mark invalid
173 Motor blocked in 1
st
stitch
175 Start error
222 Time-out monitoring
To Next Page
Loading...
Need help?
General
