Adjustment
4
● If necessary, enter the access code, see Chapter 11.05.01 Entering the access code in
the instruction manual.
● With the corresponding +/- key move the button clamp drive unit in accordance with
requirement 1, also see Chapter 11.03 Parameter input.
● Switch off the machine.
● Remove adjustment gauge 1.
● Fit the lower feed plate and button clamp holder.
If, during the fine adjustment, the setting is ± 5 increments above or below the
value in X- and Y-direction, the setting should be checked again in accordance
with requirement 2.
To Next Page
Loading...
