Pfaff 467 User Manual

9. Drawing Up The Bobbin Thread
Hold the end of the needle thread and turn the balance wheel toward you until the needle
moves down and up again. Lightly pull the needle thread to draw the bobbin thread up through
the needle hole (Fig. 10). Lay both threads back under the presser foot.
Fundamentals of Machine Operation
Always turn the balance wheel until the take-up lever is at its highest position before you
begin and after you have completed a seam. Failure to observe this rule may cause the thread
to jam in the raceway of the sewing hook or slip out of the needle eye. If the take-up lever is
at the top of its stroke, there is no need to hold both threads when sewing commences.
On special request, the Pfaff 467 can be supplied in subcl. -900 fitted with automatic needle
positioner and thread trimmer which reduces handling time to a minimum. Switching the
machine from forward the reverse sewing, raising or lowering the needle and trimming the
threads, all are controlled by foot action, thus eliminating all superfluous motions, such as
reaching for the balance wheel or the feed regulator lever and pulling up, positioning, holding
or trimming the threads.
Fig. 10
R 9458
11
From the library of: Superior Sewing Machine & Supply LLC

Pfaff 467 Specifications

General

Brand	Pfaff
Model	467
Category	Sewing Machine
Language	English