Pfaff 467 User Manual

4. Test-Running the Machine
Before you test-run the machine, carefully remove all dirt which may have accimulated In
transit. Be sure to use only a brush and a cleaning rag for this purpose.
The Pfaff 463 must never be rinsed or cleaned with kerosene because there is a danger that
the cleaning fluid enters the sealed-for-life bearings and dissolves the grease. For the same
reason, kerosene or gasoline must not be used for regular cleaning of the machine.
Never attempt to eliminate hard working of the machine by squirting oil freely into the bearings
which you believe to be responsible for this fault. If oil enters the sealed-for-life bearings, the
grease will be thinned and flung out of the bearings, thus rendering permanent lubrication
ineffective.
Before you connect the machine to the electric circuit, check to see that the line voltage is the
same as that indicated on the rating plate of the motor, and that the motor pulley turns in the
right direction. If the pulley turns in the wrong direction, merely exchange two wires in the
motor terminal box.
. R 9459
5. Removing the Bobbin Case
Raise the take-up lever to its highest position and open the bed slide so that you can see the
sewing hook. Open the bobbin case latch with the nail of your left thumb and pull out the
bobbin case by holding the latch with thumb and forefinger, as shown in Fig. 2.
While
you hold the bobbin case by its open latch, the bobbin cannot fall out (Fig. 3).
From the library of: Superior Sewing Machine & Supply LLC

Pfaff 467 Specifications

General

Brand	Pfaff
Model	467
Category	Sewing Machine
Language	English