8.4.4 In program 1:
Entering the desired backtack stitches for front and end backtacks
Precondition: Program 1 has been preselected as described under 1.2 to 1.3!
4.1 To enter the desired backtack stitches for front and end backtacks in "Program 1"
press the PM key, (LED on) and press the TE key, (LED on)
4.2 Press the paging key until the display Fig. 8.4 appears
4.3 Using the A+ / A- keys, set the desired number of front backtack stitches for the forward section,
4.4 Using the B+ / B- keys, set the desired number of front backtack stitches for the backward section,
4.5 Using the C+ / C- keys, set the desired number of end backtack stitches for the backward section,
4.6 Using the D+ / D- keys, set the desired number of end backtack stitches for the forward section,
Note:
The desired backtack stitches for the front and end backtacks of sewing program 2 can be entered as
described under 4.3 to 4.6.
However, this presupposes that program 2 has been preselected as described under 1.2 to 1.3!
The desired backtack stitches for the front and end backtacks of sewing program 3 can be entered as
described under 4.3 to 4.6.
However, this presupposes that program 3 has been preselected as described under 1.2 to 1.3!
To enter other functions, continue working in programming mode.
To finish your entry in "Program 1"
press the PM key, (LED off) and press the TE key, (LED off)
Front backtack stitches
for the forward section
Fig. 8.4
Front backtack stitches
for the backward section
End backtack stitches
for the backward section
End backtack stitches
for the forward section
p4xpd-2-en
8.8 08-08-29
To Next Page
Loading...
Need help?
General
