8.4.5 In program 1:
Entering the desired special functions for the intended seam sections
Precondition: Program 1 has been preselected as described under 1.2 to 1.3!
5.1 To enter the desired special functions in "Program 1"
press the PM key, (LED on) and press the TE key, (LED on)
5.2 Press the paging key until the display Fig. 8.5 appears
5.3 Using the C+ key = special function stop at end of seam section,
I = stop on (standard), 0 = stop off
5.4 Using the C- key = special function programmed speed or treadle-controlled speed,
I = program speed (standard), 0 = treadle-controlled speed
5.5 Using the D+ key = special function feed reverse off / on,
I = feed reverse on, 0 = feed reverse off (standard)
5.6 Using the D- key = special function manual sewing off / on,
I = manual sewing on, 0 = manual sewing off (standard)
Note:
The desired special functions of sewing program 2 can be entered as
described under 5.3 to 5.6.
However, this presupposes that program 2 has been preselected as described under 1.2 to 1.3!
The desired special functions of sewing program 3 can be entered as
described under 5.3 to 5.6.
However, this presupposes that program 3 has been preselected as described under 1.2 to 1.3!
To finish your entry
press the PM key, (LED off) and press the TE key, (LED off)
Fig. 8.5
Stop at end
of the seam section
Programmed speed or
treadle-controlled
speed
Feed reverse
off / on
Manual sewing
off / on
p4xpd-2-en
8.9 08-08-29
To Next Page
Loading...