Pfaff PicoDrive P40PD

Setting for T9 key (paging) is on mode 3 (Fig. 7.17): used to select
front and end backtack stitches for the selected program:
- A+ / A- Set stitch number A front backtack forward
- B+ / B- Set stitch number B front backtack backward
- C+ / C- Set stitch number C end backtack backward
- D+ / D- Set stitch number D end backtack forward
Setting for T9 key (paging) is on mode 4 (Fig. 7.18): used to select
program number and seam section, special function: stop at the end of the seam,
special function: constant speed (or treadle-controlled), special function: feed reverse and
special function: manual seam:
- A+ / A- Select the program number
- B+ / B- Set the seam section for which the following settings apply
- C+ Stop at the end of the seam, I = on 0 = off
- C- Constant speed (or treadle-controlled) I = constant speed 0 = treadle-controlled
- D+ Feed reverse at the end of the seam I = on 0 = off
- D- Manual seam section I = on 0 = off
Fig. 7.17
Fig. 7.18
Paging key
TE key
(Enter mode)
PM key
(Program mode)
Paging key
TE key
(Enter mode)
PM key
(Program mode)
p4xpd-2-en
7.6 08-08-29