Revision: 3.0.3
1.2 Wire Connecting
1.2.1 Power supply option
Customers should pay special attention to specify the desired power supply
Factory standard power supply is 10~36VDC/1A max.
To ensure the transmitter can work normally, please pay attention to the followings when wiring:
Ensure that power connections are made in accordance with the specifications shown on the transm
1.2.2 Transmitter Wiring
Once the electronics enclosure has been installed, the Flowmeter wiring can be connected.
Open the case, you
will find the transmitter interfaces labels from left to right as follows:
Power supply, Relay output,
interface.
Refer to the below diagram for specific connection:
1.2.3 Lengthened Cable Method
Standard cable length of sensor is
9 meters; it can be lengthened to
fluid measurement.
Flow
DC+ DC- GE
DC 10 -36V
Upstream Transducer
OCT
RL+ RL-
RELAY
10~36VDC
D116
Series Ultrasonic Flowmeter
Customers should pay special attention to specify the desired power supply
when wiring.
Factory standard power supply is 10~36VDC/1A max.
To ensure the transmitter can work normally, please pay attention to the followings when wiring:
Ensure that power connections are made in accordance with the specifications shown on the transm
Once the electronics enclosure has been installed, the Flowmeter wiring can be connected.
will find the transmitter interfaces labels from left to right as follows:
am transducer, Downstream transducer, 4-
Refer to the below diagram for specific connection:
9 meters; it can be lengthened to
be 300 meters according to
E UP+ UP- E DN+ DN-
TRANSDUCER
I+ I-
4-20mA
Blue Bushing
Black
Red
Shield
Pipe Straps
Downstream Transducer
-
OUT
Shield
Red
Black
Up-Stream
Down-Stream
Tx
A B
Series Ultrasonic Flowmeter
Page 7 of 53
Ensure that power connections are made in accordance with the specifications shown on the transm
itter.
To Next Page
Loading...
Need help?
General