PG Drives Technology R-NET BLUETOOTH MODULE User Manual

PG Drives Technology
R-net Bluetooth Modules Technical Manual | Chapter 2 - Installation
19
If you are working with more than one Bluetooth Module, then this process
must be carried out with only one Module connected at a time.
The Bluetooth Module must be put into Discovery Mode. Use the following
procedure:
 Operate your Input Device in the forward direction and hold until it
beeps. This will take approximately 10 seconds, then release.
 Operate your Input Device in the reverse direction and hold until it
beeps. This will take approximately 10 seconds, then release. (A short
beep may be heard as the directions are changed).
 The Bluetooth Module is now in Discovery Mode and ready to be
paired with a Bluetooth device.
The Discovery process will only be required once per Bluetooth
device.
6.3 PC PAIRING
If at any time during this process a message such as below appears, ignore it
by clicking on the X.

PG Drives Technology R-NET BLUETOOTH MODULE Specifications

General

Brand	PG Drives Technology
Model	R-NET BLUETOOTH MODULE
Category	Wheelchair
Language	English