Philips 3000 V2 - Page 2

PHILIPS 3000 V2
Technical specication
Power supply and output: 240 V~ 50 Hz 1850 W - 230 V~ 50/60 Hz 1850 W - 120 V~ 60 Hz 1500 W
Power consumption: During heating phase- approx. 5.6 A
Boiler: Stainless steel (230 V~) 1900 W - (120 V~) 1300 W - (100 V~) 1100 W for coee, hot water and steam dispensing
Safety system: 2 thermostats at 190°C one shot
Temperature monitoring: (NTC) variable resistor sensor - transmits the value to the electronic card
Automatic dosage: Dose adjustment controlled by the electronic system
Gear motor: 2 rotation directions; power supply 24VC
Coee grinder: Direct current motor with at ceramic grinder blades
Pump:
Ulka Type EP5/S GW approx. 13-15 bar with reciprocating piston and thermal switch 100°C 48 W, 230V, 50
Hz, 120V, 60Hz 100V, 50/60 Hz
Overpressure valve: Opening at approx. 16-18 bar
Water circuit lling time: Approx. 15 sec Max. on rst lling cycle
Heating time: Approx. 45 sec.
Grinding time: Approx. 8-10 sec.
Housing material ermoplastic material
Size (w x h x d) 215 x 330 x 429 mm (data may vary depending on the model)
Weight 7 Kg
Power Cord length 0,8 -1,2 m
Cup size Up to 152 mm
Water tank 1800 ml
Water lter In tank
Coee bean hopper capacity 250g
Coee grounds drawer capacity 15 pucks
Energy Eciency Label A
Energy saving mode consumption < 1 Wh
Pump pressure 15 bar
Boiler Stainless steel type
Safety devices ermal fuse
Nominal voltage - Power rating –
Power supply
Data stored on the below label placed inside the service door
Serial Number TW901616236813
TW90= product + production location - 1616 = year & production week - 236813 = unique following
number