Philips 3000 V2 - Test Mode Philips 3000 V2

PHILIPS 3000 V2 04 SERVICE MODE
1/9
 4.1.TestModePhilips3000V2
Philips3000V2CMF
Philips3000V2EASYCAPPUCCINO
To enter Test Mode
The machine enters in test mode by holding together Espresso and Calc-Clean button while switch-
ing on the machine by mean of the main switch on the backside of the CA.
Once entered shows Led Espresso, Led Coee ashing in series (Level 0).
There are 6 dierent level, in each level the coee-machine can execute dierent commands,
Level0:Entry Level; in this level can be done Reset to default
Level 1: The machine can test the interface (Leds & Buttons):
a) Button “Espresso”
b) Button “Coee”
c) Button “Espresso Lungo” (CMF) or “Easy Cappuccino” (AMF)
d) Button “Calc-Clean”;
e) Button “Aroma Plus” & Led Aroma Plus under the button;
f) Button “Steam/Hot-Water” & Led Steam Hot-Water under the button;
g) Button “Stand-By” & Led Stand-By under the button;
h) No Water LED
i) General Alarm LED
j) Descale LED
k) Rinsing LED
l) Dreg drawer full LED
m) No Beans LED