Philips 3000 V2 - Steamout

PHILIPS 3000 V2 04 SERVICE MODE
8/9
4.2. SteamOut
To enter in SteamOut
The machine enters SteamOut mode by holding pressed together the COFFEE button and the
CALC_CLEAN button while switching on the machine.
Once entered the machine shows LedDescaleandLedRinsingashinginseries.
If there is a failure on NTC (Ntc disconnected or in short circuit) the operation cannot be per-
formed and the LEDGeneralAlarmwillblink (turn o the machine and repair before do
Steam-out operation).
If Door is opened or drag drawer is removed LEDWASTEFULLwillbeswitchedon. To start
again the
operation insert drag drawer and close service door.
At the end of procedure LEDESPRESSOandLEDCOFFEEturnson.
When the Steam-Out is complete the following parameters are resetted to their default values:
• Length Espresso product
• Length Coee product
• Stand-By Time
• Count Coee (Ground counter)
• The request for Priming the Circuit at the rst switch on is set.
Philips3000V2CMF
Philips3000V2EASYCAPPUCCINO