Philips 3000 V2 - Central Plate; Pin Boiler; Gear Motor

PHILIPS 3000 V2 07 DISASSEMBLY
4/7
7.7. Pin boiler
Loosen the screws as illustrated and remove the boiler pin (A).
A
7.6. Central plate
Unscrew the screws shown and lift up the center plate
The following are located inside the compartment protected by
the casing:
- Electric motor (A) with gears (B) and (C) for transmission and
timing of the dispenser.
- Brewing unit present microswitch (E).
- Microswitch (D) detecting brewing unit home and work posi-
tions.
- Remove the gear (C) that meshes with the motor transmission
shaft.
- Remove the large gear (B).
- Remove the motor (A), complete with transmission shaft.
Replace the gear (B), making sure that the imprint of the arrow
is aligned with the opening containing the pin (P).
When replacing the motor and the transmission shaft,
make sure the guide runners (L) are in the right posi-
tion.
Grease the shaft thoroughly and evenly.
E
A
B
C
D
B
P
H
L
7.8. Gear motor
Loosen the screws as illustrated and remove the gear motor
cover.