Philips BDP8000 - Additional Information

24 EN
Note
 
when software updating is in progress to prevent possible
damage of this player.
Care
Caution
 Never use solvents such as benzene, thinner, cleaners
available commercially, or anti-static sprays intended for
discs.
Clean discs

the centre to the edge in a straight line movement.

Note
 
Video
 Signal system: PAL / NTSC
 Composite video output: 1 Vp-p (75 ohm)
 Component video output: 480/576i, 480/576p,
720p, 1080i
 Y: 1 Vp-p (75 ohm)
 Pb: 0.7 V-pp (75 ohm)
 Pr: 0.7 V-pp (75 ohm)
 HDMI output 480p, 576p, 720p, 1080i, 1080p,
1080p24
Audio
 2 Channel analog output
 Audio Front L + R : 2 Vrms (> 1 kohm)
 7.1 Channel analog output
 Audio Front L + R : 2 Vrms (> 1 kohm)
 Audio Surrond L + R : 2 Vrms (> 1 kohm)
 Audio Center : 2 Vrms (> 1 kohm)
 Audio Subwoofer : 1.15 Vrms (> 1 kohm)
 Audio Rear L + R: 2 Vrms (> 1 kohm)
 Digital output: 0.5 Vp-p (75 ohm)
 Optical, Coaxial
 HDMI output
USB
 Compatibility: Hi-Speed USB (2.0)
 Class support: UMS (USB Mass Storage Class)
Main unit
 Power supply rating: AC 110-240V~, 50/60 Hz
 Power consumption: 21 W
 Power consumption in standby mode: < 0.18 W
7 Additional Information
Update software
For software updates to enchance performance,
check the current software version of this player to
compare with the latest software (if available) at the
Philips website.
1 Press .
2 Select [Setup], and press OK.
3 Select [Advanced] > [Version Info.], and
press OK.
Update software via network
1 Set up the internet connection (see “Get
started’ > “Set up a network”).
2 In the Home menu, select [Setup] >
[Advanced] > [Software Update] > [Network].
» You are prompted to start upgrading
process if upgrade media is detected.
3 Follow the instructions on the TV screen to

» When the software update is complete, the
player automatically turns off and on again.
Update software via USB
1 Go to www.philips.com/support to check if
the latest software version is available for this
player.
2 
a Un-zip the download, and make sure that
the un-zipped folder is named “UPG_ALL”.
b Put the “UPG_ALL” folder in the root
directory.
3  (USB)
jack on this player.
4 In the Home menu, select [Setup] >
[Advanced] > [Software Update] > [USB].
5 Follow the instructions on the TV screen to

» When the software update is complete, the
player automatically turns off and on again.