© PSI (Photon Systems Instruments), spol. s r. o.
44
Online Control – Time
In this window the FluorPen time and date are set. You can also synchronize the time of the FluorPen device with the
computer time. This is essential for correct GPS data acquisition and therefore recommended.
Online Control – Protocols
Selection of the protocol for single measurements may be done under this tab in the software. Once the measurement is
completed the data is saved to the device and can be downloaded to the PC at a later time. Measuring of PAR is active
only in the PAR-FluorPen FP 110 (see picture below). Also, Bby pressing the Multi button in this window the Multiple
measurements can be started remotely.
To Next Page
Loading...