Photon Systems Instruments FluorPen FP 110 - 2 Technical Specification

© PSI (Photon Systems Instruments), spol. s r. o.
6
2 TECHNICAL SPECIFICATION
PAR-FluorPen & FluorPen
Protocols
PAR-FluorPen FP 110
- Ft – instantaneous chlorophyll fluorescence
- Quantum Yield
- OJIP
- Non-photochemical quenching
- Light curve
- Photosynthetically Active Radiation (measured as PPFD)
FluorPen FP 110
- Ft – instantaneous chlorophyll fluorescence
- Quantum Yield
- OJIP
- Non-photochemical quenching
- Light curve
LED lighting
LED emitter
Blue (455 nm), other wavelength on request
Saturating pulse Illumination
Up to 3,000 µmol(photon).m
-2
.s
-1
(adjustable from 10 to 100%)
Actinic Illumination
Adjustable from 10 to 1,000 µmol(photon).m
-2
.s
-1
Measuring Illumination
Up to 0,09 µmol(photon).m
-2
.s
-1
per pulse (adjustable from 10 to 100%)
Detector
Type
PIN photodiode with bandpass filters
Wavelength range
From 667 to 750 nm
Data storage and transfer
Internal memory capacity
Up to 16 Mb
Internal data logging
Up to 149,000 measurements (depending on protocol)
Data transfer
USB cable
Bluetooth (transfer up to 3Mbps for distance up to 20m)
PC software
FluorPen 1.1 (Windows 7 and higher)
Battery
Type
Li-Ion rechargeable battery
Capacity
2000 mAh
Max. charging current
0.5 A
Charging
Via USB port - PC, power bank, USB charger, etc.
Battery life
48 hours typical with full operation
Low battery indicator
Other
Sample holder
Standard leaf-clip (FP 110/S)
Detachable leaf-clip (FP 110/D)
Probe (FP 110/P)
PAR sensor cosine correction
Cosine corrected up to 80° angle of incidence
Display
Graphical display
Keypad
Sealed, 2-key tactile response
Turns off after 5 minutes of no use
Built in GPS module
Ultra-high sensitivity down to -165dBm
High accuracy of <1.5 m in 50% of trials
Size
134 x 65 x 33 mm
Weight
188 g
Operating conditions
Temperature: 0 to +55 °C
Relative humidity: 0 to 95 % (non-condensing)
Storage conditions
Temperature: -10 to +60 °C
Relative humidity: 0 to 95 % (non-condensing)
Warranty
1 year parts and labor