The MAX level mark indicates a quantity of around
1300 cc of engine oil. If the check is carried out
after the vehicle has been used, and therefore with
a hot engine, the level line will be lower; in order
to carry out a correct check it is necessary to wait
at least 10 minutes after the engine has been stop-
ped, so as to get the correct level.
Oil top up
The oil should be topped up after having checked the level and in any case by adding oil without ever
exceeding the MAX. level.
Restoration of the level from MIN to MAX requires approximately 200 cc.
Engine oil filter
The cartridge filter must be replaced every time the oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and oil drainage plug, screwing them up to the specified torque. Refit the new cartridge filter
being careful to lubricate the O-ring before the fitting. Change the engine oil.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the requirements of API SL, ACEA A3, JASO MA specifications
Oil pressure warning light
The vehicle is equipped with a warning light on the
instrument panel that lights up when the key is
turned to the «ON» position. However, this light
should switch off once the engine has been star-
ted.
If the light turns on during braking, at idling
speed or while turning a corner, it is necessary
to check the oil level and the lubrication sys-
tem.
Maintenance MP3 250 i.e.
MAIN - 10
To Next Page
Loading...
