This section describes the operations to carry out when removing the engine from the vehicle.
Exhaust assy. Removal
- Remove the Lambda probe from its support and
disconnect it.
- Undo the two exhaust manifold fixings on the
head. To undo the nuts fixing the muffler flange to
the head properly, you must use a jointed wrench
that enables you to get at the right nut as well, ac-
cording to the direction of travel, that is difficult to
get at with a traditional straight wrench.
- Undo the three screws fixing the muffler to the
support arm.
Remove the full muffler unit.
Remove the lambda probe from the manifold.
Engine from vehicle MP3 250 i.e.
ENG VE - 2
To Next Page
Loading...
