Removal
- Remove the front wheel.
- Remove the handlebar.
- Using the appropriate tool, loosen and remove
the upper ring nut, the distancing washer, the
counter ring nut and the spacer ring.
- Extract the fork.
N.B.
TAKE CARE TO SUPPORT THE FORK SO AS TO PREVENT
IT FROM COMING OFF ABRUPTLY
Specific tooling
020055Y Wrench for steering tube ring nut
See also
Removing the front wheel
Removal
Overhaul
- Check that the roller bearing does not show signs
of wear or pricking.
In case of replacement, proceed as follows:
- Support the fork in a vice.
- Insert the contrast plate in the upper end of the
steering tube
N.B.
ONLY REMOVE THE UPPER BALL BEARING IF YOU
REALLY NEED TO.
- Insert the special tool as shown in the figure.
Suspensions B 125-250
SUSP - 222
To Next Page
Loading...
