Replacement
-Remove the oil filler cap «A». - Unscrew the oil
drainage plug «B » and drain out all the oil. - Screw
the drainage plug again and fill the hub with oil.
Recommended products
AGIP ROTRA 80W-90 rear hub oil
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Locking torques (N*m)
Hub oil drainage screw 15 ÷ 17 Nm
Air filter
- Remove the left side panel.
- Remove the air cleaner cover after unscrewing
the 9 fixing screws.
- Take out the filtering element.
- Replace the air filter with a new one.
N.B.
EVERY 6,000 KM CHECK THE AIR FILTER AND IF RE-
QUIRED, CLEAN IT WITH COMPRESSED AIR. THE AIR JET
MUST BE DIRECTED FROM THE INSIDE TO THE OUTSIDE
OF THE FILTER (I.E. OPPOSITE TO THE SENSE THE AIR
FLOWS AT REGULAR ENGINE RUNNING). EVERY 6,000
KM, UPON SERVICING, REMOVE THE RETAINER AND
RUBBER COVER UNDER THE FILTER HOUSING AS
SHOWN IN THE FIGURE AND DRAIN ALL POSSIBLE OIL
DEPOSITS.
Cleaning (Every 12,000 km):
- Wash with water and car shampoo.
- Dry with short blasts of compressed air and a clean cloth.
- Soak with a 50% mixture of gasoline and oil.
- Drip dry the filtering element and then squeeze it with your hands without wringing.
- Refit the filtering element.
CAUTION
NEVER RUN THE ENGINE WITHOUT THE AIR FILTER, THIS WILL RESULT IN AN EXCESSIVE
CYLINDER AND PISTON WEAR AND ALSO IN CARBURETTOR DAMAGE.
CAUTION
WHEN TRAVELLING ON DUSTY ROADS, THE AIR FILTER MUST BE CLEANED MORE OFTEN
THAN SHOWN IN THE SCHEDULED MAINTENANCE CHART.
Recommended products
AGIP FILTER OIL Oil for air filter sponge
Mineral oil with specific additives for increased adhesiveness
See also
Maintenance B 125-250
MAIN - 48
To Next Page
Loading...
