Footrest
Engine oil
Replacement
The engine oil should be replaced after the first
1,000 km, and then every 6,000 km for the 125cc
version and 12,000 km for the 250cc version. The
engine must be drained through the net filter drain-
ing cap «B» on flywheel side; in addition, to facili-
tate the drainage, oil dipstick «A» should be
loosen. Once the engine oil has been drained, re-
move oil cartridge «C».
Since a certain oil quantity remains inside the cir-
cuit, the fill-up must be carried out with 600-650cc
of fresh oil poured through filler cap «A». Hence
start the vehicle, let the engine run for a few mi-
nutes, and then shut it back down; after approx.
five minutes, check the level and top-up if neces-
sary, without exceeding the MAX mark.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Locking torques (N*m)
Engine oil drainage plug 24 ÷ 30
See also
Engine
oil filter
Check
In 4T engines, the engine oil is used to lubricate the distribution elements, the bench bearings and the
thermal group. An insufficient quantity of oil can cause serious damage to the engine. In all 4T
engines, the deterioration of the oil characteristics, or a certain consumption should be considered
normal, especially if during the run-in period. Consumption can particularly reflect the conditions of use
(i.e. when driving at 'full acceleration' all the time, oil consumption increases).
B 125-250 Maintenance
MAIN - 49
To Next Page
Loading...
