- Remove the two screws shown in the picture.
- Remove the filter indicated in the photograph
- Check that the gasket is in good conditions
- Check the SAS filter housing for dents or defor-
mations
- Clean the SAS filter carefully. Replace the filter if
it is damaged or deformed.
To refit, carry out the removal operations but in re-
verse order.
CAUTION
WHEN TRAVELLING ON DUSTY ROADS, THE AIR FILTER
MUST BE CLEANED MORE OFTEN THAN SHOWN IN THE
SCHEDULED MAINTENANCE CHART.
CAUTION
NEVER RUN THE ENGINE WITHOUT THE SECONDARY
AIR FILTER
See also
Footrest
- Remove the flywheel cover.
- Remove the two screws fixing the SAS valve as
shown in the figure and remove the SAS valve and
the O-ring from the support
B 125-250 Maintenance
MAIN - 57
To Next Page
Loading...
