EasyManua.ls Logo

PIAGGIO X9 Evolution 500 - Removing the Air Filter; Cooling Fluid Level

PIAGGIO X9 Evolution 500
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
03_16
Removing the air filter (03_16)
Proceed as follows:
1. remove the lower left side panel;
2. unscrew the 8 screws «C» (one with a knob) and remove the air filter cover;
3. replace the filter with a new one and refit all the components in the opposite order.
The air filter needs to be checked and possibly blown down every 6000 km at an
Authorized Piaggio Service Center. Air blasts must directed from the inside towards
the outside of the filter (i.e. the opposite direction of air flow during normal engine
operation).
CAUTION
IF THE VEHICLE IS USED ON DUSTY ROADS, IT IS NECESSARY TO SERVICE
THE AIR FILTER MORE OFTEN TO AVOID DAMAGING THE ENGINE.
03_17
Cooling fluid level (03_17, 03_18)
The engine cooling system is of the forced liquid circulation type. The coolant circuit
contains approx. 1.8 litres of coolant consisting of a mixture of 50% demineralised
water and glycol ethylene-based antifreeze solution with corrosion inhibitors.
The liquid supplied with the scooter is already mixed and ready for use.
For the engine to work properly, coolant temperature must range between a minimum
value of 60 °C and a maximum value of 105 °C, as indicated by coloured references
on the indicator «D» on the analogue instrument panel. If the needle of the gauge
enters the red zone, switch off the engine, allow to cool down and check the coolant
level; if the result is normal, turn to an Authorised Piaggio Service Centre.
The fluid inspection should be carried out every 6,000 km when the engine is cold,
following the methods indicated below.
73
3 Maintenance

Table of Contents

Other manuals for PIAGGIO X9 Evolution 500

Related product manuals