Pilz PNOZ m B0 - Page 27

Operation
Operating Manual PNOZ m B0
1002660-EN-07
27
Display Example Description
SHOW OPERATING INFO
Displays specific operating
parameters of the base unit
and expansion units
Pos: 0
10.000ms
24.0V
25.0°C
Cycle:
Supply:
Temp:
Pos: 1
f1: 1.000Hz
f2: 0.000Hz
1st line: Module position
(Pos)
2nd to 4th line: Specific op-
erating parameters
e.g.:
Cycle time
Supply voltage
Operating temperature
Frequencies
SHOW ERROR STACK
Show error stack
Show
error stack?
Shows the error stack
entries
ERROR STACK
Error stack entries
1/64
PA: 00 00 00
EC: 83
00 00
EN: 01
CH: A
1st line: Consecutive num-
ber
2nd line: Error class (EC)
and error information (EI)
3rd line: Error number (EN)
and error parameter (PA)
4th line: Continuation of er-
ror parameter (PA)
IP ADDRESS
IP address of base unit
(only appears on base units
to which a communication
module with Ethernet inter-
face is connected)
IP Address
169.254.60.1/
255.255.00
2nd and 3rd line: IP address
INTERFACE
Interface
(only appears on base units
to which a communication
module is connected)
Interface
USB
Show selected interface /
on expandable base units:
Select interface
STOP Device?
Stop device
STOP Device?
Bring device to a STOP con-
dition
RESET PROJECT?
Delete project
RESET
Project?
Delete project from the base
unit's memory