Pilz PNOZ mm0p - Operation; Rotary knob; Function; Pull out and retract the knob

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
7-1
7.1 Rotary knob
7 Operation
77000OperationOperation7-7.1Ro tary knob7100Rotar y knob7-
7.1.1 Function
Function7-Inbetriebnahme_Drehknopf_Funktion
The menu settings are made on the unit's display via a rotary knob. You
have the option to make the settings on the knob by hand or with a
screwdriver. If you make the settings with a screwdriver, the knob can
remain within the unit.
7.1.2 Pull out and retract the knob
Pull out and retract the knob 7-Inbetriebnahme_Drehknopf_Bild
Inbetriebnahme_Drehknopf_Funktion_heraus_und_zurck
The rotary knob:
 (A) should be pulled out until it clicks into position
 (B) then released and retracted back into the unit:
– Press the latch on the side of the rotary knob (1) towards the centre
of the knob. This releases the rotary knob.
– Press the knob downwards (2) while keeping the latch held down.
7.1.3 Rotate and press the knob
Rotate and press the knob 7-Inbetriebnahme_Drehknopf_Funktion_drcken_drehen_anzeigen
The settings are made via the rotary knob, as follows:
Press the knob
 Confirm selection/setting
 Switch to menu
Rotate knob
 Select menu level
A
1.
2.
B