Pilz PNOZ mm0p - Default Chapter; Table of Contents

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
1
Contents
Contents
Contents Page
Chapter 1 Introduction
1.1 Validity of documentation 1-1
1.1.1 Retaining the documentation 1-1
1.2 Overview of documentation 1-2
1.3 Definition of symbols 1-3
Chapter 2 Overview
2.1 Unit structure 2-1
2.1.1 Range 2-1
2.1.2 Unit features 2-1
2.1.3 Chip card 2-2
2.2 Front view 2-3
Chapter 3 Safety
3.1 Intended use 3-1
3.1.1 System requirements 3-1
3.2 Safety regulations 3-2
3.2.1 Use of qualified personnel 3-2
3.2.2 Warranty and liability 3-2
3.2.3 Disposal 3-2
3.2.4 For your safety 3-3
Chapter 4 Function description
4.1 Device properties 4-1
4.1.1 Integrated protection mechanisms 4-1
4.1.2 Operation 4-1
4.1.3 Block diagram 4-1
4.1.4 Diagnostics 4-2
Chapter 5 Installation
5.1 Control cabinet installation 5-1
5.1.1 Dimensions 5-1
5.1.2 Mounting distances 5-2
Chapter 6 Commissioning
6.1 General wiring guidelines 6-1
6.2 Preparing for operation 6-2
6.2.1 Function test during commissioning 6-2
6.2.2 Using the chip card 6-2
6.2.3 Commissioning the PNOZmulti safety
system
6-3
6.2.3.1 Load project from chip card 6-3
6.2.3.2 Load project via USB port 6-3