PSS(1) ControlNet Adapter - Hardware Manual 1-1
This manual describes the hardware of the communications modules
• PSS ControlNet Adapter and
• PSS1 ControlNet Adapter.
To fully understand this manual you will need to be conversant with the
information found in the general documentation for the PSS-range (Safety
Manual, System Description, Installation Manual, Programming Device
and Programming Manual).
The software is described in a separate manual “ST SB ControlNet”.
To fully understand the bus-specific requirements and any associated
requirements, you will need to be familiar with the “ControlNet Internatio-
nal Specification” Version 2.0 from 31. March 1995.
This manual is intended for instruction and should be retained for future
reference.
Introduction
To Next Page
Loading...
