Captain-i, Installation Guide 24
5.2.5 Subscriber ID for partitions and/or double
report
In this screen you program subscriber IDs for partitions and/or Double Report.
The CAPTAIN-i allows each Monitoring Station subscriber to be given a personal
customer ID for telephone communication and a number for radio communication.
These numbers, which can be the same number or two different ones, identify the
subscriber upon communication with the Monitoring Station. A second personal
customer ID can be programmed for double reporting, i.e. reporting to two Monitoring
Stations.
In case partitions are used, the second programmed ID will be used for the second
partition.
Partitions
enabled
Double report
enabled
2
nd
ID is
used for...
1 X X Not used
2 X
2
nd
CMS
3
X 2
nd
Partition
4
2
nd
Partition
Table 3. Partitions & double report
Important:
A subscriber number of 0 is as if no subscriber number was programmed,
and thus there is no communication with the Monitoring Station
The largest subscriber number for PIMA format is 8000 (for other
formats, this depends on the specific format)
Enter Technician Menu [ [ and receive the following screen:
Subscriber I.D
Ph:0 Rd:0
Tel. (PSTN)
account no.
Radio
account no.
. [ Telephone (PSTN) ID [ Radio ID
[ to exit, OR [ to program Subscriber IDs for second CMS or
partition #2:
DblRep. Or Part.
Ph:0 Rad:0
Tel. (PSTN) account no. Radio account no.
[ Program Telephone (PSTN) ID [
[ Radio ID [
To Next Page
Loading...
Need help?
General
