Captain-i, Installation Guide 36
5.4.10 Setting exit delay time
[ , the display will show: “Delay times", [ [ and the display
will show: "Exit Delay time:” enter the required delay time in seconds (up to 250
seconds)
5.4.11 Allocating users to partitions
In this screen you assign user codes for partitions #1 and #2.
A user allocated to both partitions can arm/disarm the entire system.
Technician Menu
[ [ (“User Partitions”) [ The following screen
is displayed:
Users for Part 1
++++++++
12345678910111213141516
[ Mark “+” above the user/s no. designated for partition #1 [ to allocate
users to Partition #2, in the same manner. When finished
[ .
To exit at any stage, press
[
Important:
Entering the Primary Code + when one of the partitions is already
armed will arm the other partitions as well.
Entering the Primary Code +
when both partitions are armed will
disarm the entire system
5.5 General Issues
5.5.1 Changing the Technician code
[ , the display will show: “Technician code” [ and enter the new
technician code (4-6 digits)
The technician code provides access to the Service menus from the customer menu.
Important: When the control panel is re-connected to power, the
Primary Code and the Technician Code default to the factory settings for
30 seconds (i.e., Primary Code is 5555 and Technician Code is 1234).
This is useful when these codes where lost and new ones should be
programmed.
In case the technician code begins with 0 (zero), it will not default to
1234 when reconnecting the power.
To Next Page
Loading...
