Captain-i Installation Guide 37
5.5.2 Defaulting the system
[ , the display will show: "Defaults?". [ , the display will show:
"Are you sure?”
[
The CAPTAIN-i allows restoring all system parameters to their factory defaults (except
for the Master and Technician codes). See Appendix A – Default system parameters on
page 44 for the factory default values.
Note: Defaulting erases all previous programming (memory, codes, etc.)
5.5.3 Fast loading
[ [ , the display will show: "Fast-Load?"' press 1, 2, 3 or 4
Connect the PRG-22 to an LCD keypad using a special connector.
The CAPTAIN-i allows fast programming with the use of PRG-22, saving programming
time of parameters such as Monitoring Station.
Important: In case the system was installed with an LCD keypad,
connect the programmer to the installed unit. In case the system was
installed with a LED/digital keypad, connect the keypad to an LCD
keypad, and connect the LCD keypad to the programmer. See figure on
page 17
To Next Page
Loading...
