8 Captain-i - Installation Guide
♦ Z1-Z6: Zones Inputs: Inputs for dry contact detectors from any zone, including
EOL protected.
♦ (+V): Detectors Voltage: Power supply output for PIR detectors, ultrasonic
detectors, etc. The output is protected by F2 thermal fuse (protects the keyboard
too)
♦ SMOKE: Voltage Output for Smoke Detectors: The output is switched to
minus (-) when smoke alarm occurs, for resetting the smoke detectors. When a
zone programmed to “Fire” response is activated, its power is temporarily
disconnected.
To manually reset the output, press long
.
SMOKE output can be programmed to work inversely, i.e. disconnected in normal
mode and switched to (–) when activated.
♦ PGM: Auxiliary Output: This output can be programmed either to be
disconnected or to be switched to GND, in case of alarm (see sections 5.4.4 and
5.4.6 ). MIC-200 microphone or VU-20N voice Unit can be connected to this
output.
♦ SRN: Siren Output: Two sirens (with or without a driver) can be connected to
this output in parallel (See section 3.1.5). F1 thermal fuse protects it.
♦ KEYPAD: Keypads Connection: The output has four terminals: (+V), (–), IN
(data), OUT (data). F2 thermal fuse protects the voltage supply (together with
detectors voltage).
The system can have up to 6 keypads connected to it.
Notes:
All PIMA LED keypads can be connected to the system.
Do not connect anything but keypads to the keypad power source
connectors
♦ SRN: Siren Output: Two sirens (with or without driver) in parallel can be
connected to this output (See section “ 3.1.5”). F1 thermal fuse protects it.
♦ AUD: Connection to Microphone or Voice Unit: See sections 3.1.8, 3.1.9 and
5.1.3.
♦ LINE: Connections to Telephone Line: It is recommended to connect the
inputs as close as possible to the line source to prevent tampering
♦ SET: Connections to Telephone Sets: Terminals for connecting fax, answering
machine, telephones etc.
♦ P1: Transmitter: A quick connector for RF and GSM transmitters
♦ P2: Keypad: A quick connector to connect a technician keypad
For setting the jumpers, see page 12.
To Next Page
Loading...
